HyperV with VLANID does not work!

Hello, 

I created a nic teaming with 3 network cards and a virtual switch. 

My need is to create the following scenario: 

- Nic Teaming with 3 network cards 
  - VEthernet (Live migratory-on) - 1 VLANID 
  - VEthernet (ClusterHB) - VLANID 2 
  - VEthernet (Management \ Backup) - VLANID3 

I have two switches cascaded in (LinkAgredation / Trun-k). 

My server is connected as follows: NIC1: SW1, NIC2: SW2, CIN3: SW1 

I asked for support networks configure the switch ports which I will use for my NICs in Trunk. 

Here we go: 

- I created the Nic Teaming in Independent mode - HyperV-Port 
  - Created vEthernet (Live migratory-on) - 1 VLANID 
  - Created vEthernet (ClusterHB) - VLANID 2 
  - Created vEthernet (Management \ Backup) - VLANID3 

My main network I'm connected is in VLANID 3 (172.16.16.50) and try to ping the vEthernet (Managment \ B-ackup) - VLANID3 that has the IP: 172.16.16.60 does not work. 

I removed the NIC Teaming and put the IP: 172.16.16.60 on each (NIC1, NIC2, CIN3) to verify if there was any problem in the SW configuration, but the ping worked normally. 

The problem only occurs after creating the nic teaming. 

PS1: I put the IP: 172.16.16.60 directly in the Nic Teaming driver, I type changes Nic Teaming for static and not funciounou too. 

PS2: I created a second nic teaming, as your blog and assigns putting VLANID3 and neither worked an IP. 

What am I doing wrong? 

Thank you....