Hello,
I have a problem with the initial Hyper-V replication of one of my VMs and I'm out of ideas. I will realy appreciate some help. The replication health goes critical with event ID 32022. Then replication resumes after one minute and exactly after two hours (+/- 2-3 minutes) the error repeats. Both my Hyper-V host servers (primary and replica) are Windows 2016 Datacenter.
Currently both my servers are located next to each other (over a switch).
I'm trying to replicate 4,2 TB distibuted into 4 virtual disks and it takes a lot fo time, However the same issue occurs even when trying to replicate with the VM turned off (so no changes to its virtual disks).
So every two hours, I have in the log the following::
---
Event ID32022
The description for Event ID 32022 from source Microsoft-Windows-Hyper-V-VMMS cannot be found. Either the component that raises this event is not installed on your local computer or the installation is corrupted. You can install or repair the component on
the local computer.
If the event originated on another computer, the display information had to be saved with the event.
The following information was included with the event:
[My VM name]
1386FE00-0F0F-4931-9FB3-6C71993F335B
%%2147952454
0x80072746
The locale specific resource for the desired message is not present
---
Followed by:
Event ID 32315
Hyper-V failed to replicate changes for virtual machine '[My Vm]' (Virtual machine ID 1386FE00-0F0F-4931-9FB3-6C71993F335B). Hyper-V will retry replication after 1 minute(s).
---
Thanks for your help in advance!
Regards