How to connect to my VM directly after creating it.

Dear Sir,

I am a new admin and have 5 Blade server "HP ProLiant BL660c Gen8".

I access these servers through HP enclosure.

I have to install Hyper-V on server 1 which consisted of the OS windows server 2012 R2 Datacenter edition.

I created a plan to create 5 Hyper-V VM's on the physical server and I requested the IT department network Admin that I want these 5 VM's to able to connect to each other.

The network Admin created a Trunking configuration on the physical server and after this setup he provided me Hyper-v node IP address and 5 more IP addresses for the 5 Hyper-v VM's.

Now it was left to me to Add the Hyper-v role and create 5 VM's.

While Adding the Hyper-V role, I was asked in the middle of the setup to add the network adapter for connecting to external network.

I went inside the network connection settings and I see one network adapter "Microsoft Multiplexer" which had the IP address of the Hyper-V node which was given  to be me by Network Admin.

Besides this I found following Network Adapter: (Mgmt,Trunk):(Mgmt A, Trunk A);(Mgmt B, Trunk B) =Total 6 Network Adapter out of which only "Mgmt" was configured with the IP address of the Hyper-v node given by my Network Admin. Remaining all other Network adapters IPV4 configuration was unchecked except "Mgmt" 

So I selected the "Mgmt" connection while Installing the Hyper-v role

SO I chose this Network connection for adding the Hyper-V role.

My question: Did I chose the correct Network Adapter.

After doing this I created a VM-1 and tried to assign the IP address given by the Network Admin. But the network Admin did not provide me the default gateway so I used the deafult gateway according to the IP address and used the last digit as "1" like a general installation.

Now my question is: 1.How can I use this VM to be used as a Virtual server?

2. I would like to open this VM through my browser by entering the IP address of this VM-1. How can I do this?

Because I access my physical server through the IP address. SO in the similar way I want to access this VM-1 through the IP address OR is there any alternate way to access this VM-1 separately.

My Requirement: I need to give VM-1 access to another admin to Install his application on it. SO how to give him to access this VM directly?

This is my main query.

Waiting for your reply.

Thanks & Regards,

Ahmed