Hi,
I am a bit confused over this hyper-v replica stuff, well I wasn't when I started but I am now. 2012 R2 allows 30 seconds, 5 minutes and 15 minutes replication points... but when i try to use a test failover or a failover i dont see any of my 30 second replication points, all i seem to see is the latest recovery point, a standard recovery point and an application consistent recovery point. none of which are remotely within a few minutes of each other.
for this particular example my replication settings are as follows:
frequency of changes sent to replica server - 30 seconds
coverage provided by recovery points - 24 hours
VSS snapshot frequency - 4 hours
under my replication health right now it shows 173 out of 173 successful replication cycles, i was expecting to see 173 possible points to recover to.
can anyone provide any guidance on this?
thanks
Steve