hyper-V cluster VLAN network configuration

Hi Everyone,

I have a Windows 2008 R2 Hyper-V Cluster working fine. It has actually two virtual networks and a cluster network, and I and going to add a 10 Gbps NIC to both nodes in the cluster.

My aim is to send/receive all network traffic used by virtual machines through that new 10 Gbps NIC, using VLANs I already have in my physical switches. Is it posible to do this once the cluster is created and working? How should I proceed?

Once I have done it, I would like to change all virtual NICs in virtual machines to the new virtual networks and remove the old virtual networks. Any special direction on how to do it? 

Thank you very much,

Best Regards.

David.