This a guide about how to install the Integration service 3.5 on CentOS 6.2 x86_x64.
Before install the Integration service you can use the following command to check whether the Integration service is installed or not (Figure 1).
#lsmod | grep hv
Figure 1: Check the Integration service
If there is no output, it means that the Integration Service is not installed. We can following the steps below to install it.
1. Download the Integration Service 3.5 image.
http://www.microsoft.com/en-us/download/details.aspx?id=41554
2. Install the Integration Service image.
1) Open Hyper-V Linux guest VM console.
2) Click Media -> DVD Drive -> Specific the Integration Service image location, insert Disk.
3) If automount is enabled, the Integration Service image will automatically mounted. If not, please use the following command to mount the image (Figure 2).
#mount /dev/cdrom /media
Figure 2: Mount the Integration Service image
4) Open the console, switch to root user and then locate the image directory (Figure 3).
Figure 3: Locate the image directory
5) Use following command to start the installation of Integration Service.
#./install.sh
System will start the install process (Figure 4).
Figure 4: Install the Integration service
6) Reboot system.
3. Verify the installation.
After system boots up, we can confirm the command below to verify the result (Figure 5):
#lsmod | grep hv
Figure 5: Verify the isntallation
Please click to vote if the post helps you. This can be beneficial to other community members reading the thread.