Hey,
We are trying to set the correct settings for VMQ on 2012 R2 on our physical servers.
Switch settings, Independent mode, Dynamic.
CPU, HT 2x12, lp 48.
Receive queues is 15 per port, 2x10GB.
Per default it sets to base 0, max 16. This seems to work fine except that it reports alot of errors in the event logg as we are not using the correct settings for sum queue mode.
All settings with baseprocessornumber 0 seems to work fine, but on the second port if we set it correct to not overlapp it doesnt work.
Any suggestions?
//Johan